PHYS 207 - University Physics II Laboratory

Equipment List

Equipment listed is for each of eight (8) identical student table stations unless otherwise noted .

Lab 1: Introduction to Research

Lab 2: Electric Charges and Electric Fields

• Computer with Logger Pro Software
• Lab-Pro Interface
•   Scotch Tape
•   Pith Balls
•   Electrostatics Stand
•   Point Charge Board
•   Aluminum foil covered ball
•   Paper towel
•   Balloon
•   1 & 2g weights
•   String

Lab 3: Electric Field

Lab 4: Electric Fields - The CRT

Lab 5: Equipotentials

• Computer with Logger Pro Software
• Lab-Pro Interface
•   Pasco Function Generator
•   Parallel Plate Board
•   Dipole Board
•   Point Charge Board
•   Red & White Probe Wires
•   Probe Wires set in rubber stopper
•   (2) Voltage Probes
•   Plastic Water Tray
•   500 mL Beaker
  

Lab 6: Magnetic Fields

• Computer with Logger Pro Software
• Lab-Pro Interface
•   Pasco Board
•   2 batteries
•   Piece of magnet wire about 1 foot long
•   Light bulb
•   Pre-wire a red wire to the top battery (+) side and a black wire to the bottom battery (–) side. Connect the batteries in series with a third short wire.
•   Magnetic compass
•   Bar magnet

Lab 7: Current

• Computer with Logger Pro Software
• Lab-Pro Interface
•   Pasco Board
•   connecting wires
•   2 Batteries
•   3 1.5v Light Bulbs
•   2 Current Probes

Lab 8: RC Circuits

• Computer with Logger Pro Software
• Lab-Pro Interface
•   Pasco Board
•   Knife switch
•    1.5v Light bulb
•   connecting wires
•   voltage probe
•   current probe
•   (2) D cell batts
•   10 Ohm Resistor
•   3000 microfarad capacitor
•   33000 (or greater) microfarad capacitor

Lab 9: Magnetic Fields and Force

Lab 10: Flux and Electric Generators